AT89S8253-24JU
Features
Compatible with MCS
-51 Products
12K Bytes of In-System Programmable (ISP) Flash Program Memory
– SPI Serial Interface for Program Downloading
– Endurance: 10,000 Write/Erase Cycles
2K Bytes EEPROM Data Memory
Endurance: 100,000 Write/Erase Cycles
64-byte User Signature Array
2.7V to 5.5V Operating Range
Fully Static Operation: 0 Hz to 24 MHz
Three-level Program Memory Lock
256 x 8-bit Internal RAM
32 Programmable I/O Lines
Three 16-bit Timer/Counters
Nine Interrupt Sources
Enhanced UART Serial Port with Framing Error Detection and Automatic
Address Recognition
Enhanced SPI (Double Write/Read Buffered) Serial Interface
Low-power Idle and Power-down Modes
Interrupt Recovery from Power-down Mode
Programmable Watchdog Timer
Dual Data Pointer
Power-off Flag
Flexible ISP Programming (Byte and Page Modes)
– Page Mode: 64 Bytes/Page for Code Memory, 32 Bytes/Page for Data Memory
Four-level Enhanced Interrupt Controller
Programmable and Fuseable x2 Clock Option
Internal Power-on Reset
42-pin PDIP Package Option for Reduced EMC Emission
Green (Pb/Halide-free) Packaging Option
1. Description
The AT89S8253 is a low-power, high-performance CMOS 8-bit microcontroller with
12K bytes of In-System Programmable (ISP) Flash program memory and 2K bytes of
EEPROM data memory. The device is manufactured using Atmel’s high-density non-
volatile memory technology and is compatible with the industry-standard MCS-51
instruction set and pinout. The on-chip downloadable Flash allows the program mem-
ory to be reprogrammed in-system through an SPI serial interface or by a
conventional nonvolatile memory programmer. By combining a versatile 8-bit CPU
with downloadable Flash on a monolithic chip, the Atmel AT89S8253 is a powerful
microcontroller which provides a highly-flexible and cost-effective solution to many
embedded control applications.
3286H–MICRO–9/05
8-bit
Microcontroller
with 12K Bytes
Flash and 2K
Bytes EEPROM
AT89S8253
The AT89S8253 provides the following standard features: 12K bytes of In-System Programma-
ble Flash, 2K bytes of EEPROM, 256 bytes of RAM, 32 I/O lines, programmable watchdog timer,
two data pointers, three 16-bit timer/counters, a six-vector, four-level interrupt architecture, a full
duplex serial port, on-chip oscillator, and clock circuitry. In addition, the AT89S8253 is designed
with static logic for operation down to zero frequency and supports two software selectable
power saving modes. The Idle Mode stops the CPU while allowing the RAM, timer/counters,
serial port, and interrupt system to continue functioning. The Power-down mode saves the RAM
contents but freezes the oscillator, disabling all other chip functions until the next external inter-
rupt or hardware reset.
The on-board Flash/EEPROM is accessible through the SPI serial interface. Holding RESET
active forces the SPI bus into a serial programming interface and allows the program memory to
be written to or read from, unless one or more lock bits have been activated.
Related Parts
|